Home » » How to Build a Garden Arbor Out of Branches and Limbs

How to Build a Garden Arbor Out of Branches and Limbs

Written By Unknown on Sabtu, 19 Oktober 2013 | 11.22

Intuition is better than detailed planning when your garden project is building an arbor from limbs, twigs, branches and found wood. With a little knowledge and a lot of imagination, you can fashion a sturdy frame, bracing lintels and a leafy canopy into a garden bower that's functional, inexpensive and truly unique.

Instructions

    1

    Select your site by determining how you want to use your arbor. Arbors are often sited at property or garden gateways, atop a stairway slope or as a boundary marker between home and garden. If you're planning to use your arbor to support growing flowers or vegetables, select a sunny site with good soil and adequate drainage. You may also slip a chair or bench beneath the arbor canopy and snap your green bean harvest on-site by placing your arbor at the entrance to your garden.

    2

    Locate 6 sturdy limbs or small trees for an arbor that will be about 6 feet high and 4 feet wide. They should be relatively straight and at least 7 feet long. Use loppers and clippers to remove any twigs or branches that are growing outward from the limb, but leave the notches in place.

    3

    Lay your 6 sturdy limbs out flat near the site you have selected. These will be your garden arbor posts and form the four corner posts, or arbor frame, and two top lintels.

    4

    Cut four of the posts to approximately the same height. Keep in mind you'll lose about 8 inches from your final arbor height when you plant the limbs into the ground.

    5

    Dig four holes at least 8 inches deep and about 4 feet apart to mark your future arbor's corners.

    6

    Place your corner posts in the holes. Back-fill each hole securely with gravel, clay and stones, tamping the dirt down with your foot every 3 inches until the post is secured.

    7

    Trim the remaining two long limbs to approximately the same size as each other, about 6 feet long.

    8

    Use the excess wood, if needed, to brace the corner posts.

    9

    Lay one limb horizontally across the two front corner posts, leaving about a foot of overhang on each side. This forms your front lintel.

    10

    Use wood screws, twine or wire to secure the lintel to the corner posts. You could also notch the corner posts with a small hatchet to open a space where the lintel could be cradled while being secured.

    11

    Repeat the lintel-attachment process with the second set of corner posts and the last remaining long limb.

    12

    Begin building up the arbor's sides by laddering smaller branches and limbs horizontally to connect the front left and back left corner posts, then the front right and back right corner posts.

    13

    Secure each laddered stair with wood screws or twine. Start at the base of the arbor and work your way up. You can make your sides as open or dense as you like. Make creative use of the branches and twigs that you have gathered to use notches, forks and meandering stems as connectors or braces.

    14

    Fill in the openings with more sticks and twigs until you've achieved the desired effect.

    15

    Use the thin, wand-like branches from such trees and bushes as willow trees, spicebush, sassafras and honeysuckle to build the canopy. Choose the longer pieces, at least five feet long, to form the base of your canopy, draping the ends across the tops of your arbor's side walls, and allowing for some overhang on both sides.

    16

    Secure the canopy base by intertwining the pieces with each other. You can use twine or florist's wire to secure the base to the walls and to the lintels for improved stability in wind and weather.

    17

    Continue adding twigs and branches until your canopy is complete.



  • How to build an entry arbor - introduction

    www.buildeazy.com/arbor.html

    Author: Les Kenny, Category: woodworking projects, Content: How to build an entry arbor, page 1 introduction


  • How to Build a Branch Arbor eHow

    www.ehow.com Home & Garden Garden & Lawn Garden Furniture

    How to Build a Branch Arbor. Building an arbor for your porch or garden can be fun and rewarding. An arbor provides shade, protection from rain, and most of all, a ...


  • How to build a pergola or arbor - BuildEazy

    www.buildeazy.com/fp_pergola.html

    how to build a walk thru garden pergola. Free plans and instructions


  • GardenGuides - How to Build a Garden Fence From Branches Garden ...

    www.gardenguides.com Plant Supports Fences & Cages

    How to Build a Garden Fence From Branches. In the medieval garden, fences were used to define the shape of the garden, create raised beds and keep livestock out.


  • How to Make a Twig Arbor eHow

    www.ehow.com Special Outdoor Projects

    How to Make a Twig Arbor. A natural rustic arbor is made from old branches and twigs usually found in the backyard. You can also create some unusual-looking natural ...


  • How To Prune A Tree - TreeHelp.com: Tree Care Made Easy

    www.treehelp.com Learning Center How-To Articles

    A tree may need pruning for a variety of reasons: to remove diseased or storm-damaged branches to thin the crown to permit new growth and better air circulation


  • How to Bend Branches to Build a Trellis Garden Guides

    www.gardenguides.com Plant Supports Trellises

    How to Bend Branches to Build a Trellis. A trellis archway invites people to follow a path, often leading to other interesting and attractive garden spots. Freshly ...


  • About.com Landscaping - How to Build Garden Arbors - Cheap

    landscaping.about.com/cs/accentpieces/a/garden_arbor.htm

    Wondering how to build garden arbors? I supply an overview with pictures, tips on shopping for cheap pressure-treated lumber, a supply list and design advice.


  • WonderHowTo - How to Make a whistle out of a piece of willow ...

    survivial-training.wonderhowto.com/how-to/make-whistle-out-piece...

    Andrew Price of Dryad Bushcraft demonstrates how to make a whistle out of a piece of willow that could be useful for fun and recreation as well as survival situations.


  • Southwest Yard & Garden - How-to videos - NMSU: College of ...

    aces.nmsu.edu/ces/yard/howtovideo/welcome.html

    How A Micro-Climate Works. New Mexico State University, Southwest Yard & Garden, Gardening, plants, Curtis Smith, Rick Daniell, Dona Ana County Master Gardener ...


  • How to Prune an Arborvitae DoItYourself.com

    www.doityourself.com Trees & Shrubs Tree & Shrub Care

    Many species of Arbovitae do not require pruning and will naturally take on an attractive pyramid shape.


  • Gardening Articles - Find Gardening Related Articles on ...

    www.articlesbase.com Home Improvement

    If you enjoy gardening, and want to develop your garden, you can learn a lot from our articles here. Whether you are looking to garden inside or outside we have ...


  • Make a Tree Rope Trap Wonder How To

    tag.wonderhowto.com Make a tree

    How to Build a tree string noose trap Build a tree string noose trap Materials needed: five feet of rope, knife, various size sticks and a sapling tree.


  • Better Homes and Gardens - Garden Structures

    www.bhg.com Gardening Landscaping Projects

    Enhance your landscape with arbors, pergolas, or other garden structures. From Better Homes & Gardens


  • How to prepare branch cutting of fig tree to create new plant ...

    www.botanicalgarden.ubc.ca/forums/showthread.php?t=18317

    Archives (no new threads) > Plant Propagation ... How could I prepare a branch cutting from a fig tree to create a new plant? ... Quote: Originally Posted by Young ...


  • How To Build a Teepee Trellis for Pole Beans Veggie Gardener

    www.veggiegardener.com Discover How-to

    A teepee trellis is a great way to groe pole beans. Learn how to build a teepee trellis for pole beans with this simple guide.


  • Beautiful Arbor Pictures - Squidoo

    www.squidoo.com Landscaping Walks and Pathways

    Garden Arbors add architectural interest to a landscape, not to mention a little whimsy. Featuring rustic Garden Arbor designs in Wood and striking Metal Patio Arbor ...


  • Save On Crafts - DIY Making Iced Branches

    www.save-on-crafts.com/icedbranches.html

    DIY Making Iced Branches. How to make your own iced branches for displays and decorations with Colorfill Diamond Vase filler- 1 lb bag or 2 lb bag


  • How to Create a Bonsai Tree: 8 Steps (with Pictures) - wikiHow

    www.wikihow.com Gardening Indoor and Patio Plants

    How to Create a Bonsai Tree. Bonsai trees are miniature trees that are grown in containers as a form of Japanese art. They are great for small apartments or offices ...


  • WonderHowTo - How to Make Aspirin from a Willow Tree Home

    home-remedies.wonderhowto.com/how-to/make-aspirin-from-willow-tree...

    In this article, I will be showing you how to make a crude form of aspirin from the bark of a willow tree. It is a great remedy for headaches, hangovers, and other ...

  • Free Arbor Trellis Plans - Free Arbor Trellis Plan -- Old ...

    wayneofthewoods.com/free-trellis-plans.html

    how to build a wood arbor, Free Trellis arbor Plans, free wood arbor building plans, free garden arbor plans

  • Pruning 4: How to Prune - Garden.com

    www.garden.com/garden-articles/pruning-4-how-to-prune/73

    Pruning is a necessary part of tending a garden or landscape; it plays an unrecognized but vital role in developing plants with vibrant, sturdy branches and outgrowths.

  • Bob Vila - Home Improvement, Home Repair And Home Renovation

    www.bobvila.com

    Inspirational ideas and expert advice from Bob Vila, the most trusted name in home improvement, home renovation, home repair, and DIY.

Share this article :

0 komentar:

Posting Komentar

 
Support : Your Link | Your Link | Your Link
Copyright © 2013. Gazebo - All Rights Reserved
Template Created by Creating Website Published by Mas Template
Proudly powered by Blogger